Ford Racing Gear Break In Period

Interested in racing? We have collected a lot of interesting things about Ford Racing Gear Break In Period. Follow the links and you will find all the information you need about Ford Racing Gear Break In Period.

Break in period for gears? | Ford Mustang Forums

https://www.corral.net/threads/break-in-period-for-gears.261640/

You do have a break in period. You have to heat the rear end up for 30 minutes and let it completly cool back down and then do it again. After that is done you have to put 200 miles of easy driving like highway or no hard acceleration on it. Then if for towing use, you have to do another 500 miles of breakin before you beat on it. B-rad from the BU

Break in period? | Ford Forums

https://www.fordforums.com/threads/break-in-period.119356/

The main thing is to load the engine by opening the throttle hard in 2nd, 3rd, and 4th gear. The best method is to alternate between short bursts of acceleration and deceleration. You don't have to go over 65 mph to break in your engine. Also, make sure that you're not being followed closely by another car when you decelerate!

New Gears: break-in period? - Ford F150 Forum - Community ...

https://www.f150forum.com/f4/new-gears-break-period-250486/

Gearing will effect this. In regards to the brake in period I wouldn't be as concerned with long trips as I would harsh acceleration or heavy towing. Braking in allows the gears to wear to each other. So keeping undue stress off the gears is important. As such changing the oil will remove any contaminants like metal shavings.

Break In Period | Ford Mustang Forum

https://www.allfordmustangs.com/threads/break-in-period.49823/

This process is usually done @ around 1000°F - heat cycles of 200°F at the rear end might have a slight influence on a break in, but they do not have the same impact as regular wear since it is way below the stress releaving and nitriding processes temperature. More important is the surface of the gears.

New Gear Break-In Procedure - East Coast Gear Supply

https://eastcoastgearsupply.com/ft-1479-new-gear-break-in-procedure.html

Please follow the below guidelines to ensure a proper break-in and long life of your gears. • Only use high quality gear oils. ECGS recommends Lucas non-synthetic 85W-140 • On initial run, drive lightly for 15 to 20 minutes then stop to allow differential to cool completely for 20 to 25 minutes.

Got enough information about Ford Racing Gear Break In Period?